JB/T 10231.13-2017代替 JB/T 10231.13—2002
刀具产品检测方法第13部分∶锯片铣刀
Tool inspection methods—Part 13: Metal slitting saws
2018-04-01 实施
2017-11-07 发布
目 次
前言………………………………………………………………………………………………………………………………………………………………1
1 范围………..………………………………………………………………………………………………………………………………………………………1
2 规范性引用文件………………………………………………………………………………………………………………………………….1
3 检测依据…………………………………………………………………………………………………………………………… 1
4 外观的检测……………………………………………………………………………………………………………………………………………………….1
5 表面粗糙度的检测…………………………………………………………………………………………………………………….1
6 圆跳动的检测……………………………………………………………………………………………………………………1
6.1 检测方法...……………………………………………………………………………………………………………………………………….1
6.2 检测器具…………………………………………………………………………………………………………………………………………………………….2
7 铣刀厚度及工作部分外径的检测………………………………………………………………………………………………………………….2
8 内孔的检测……………………………………………………………………………………………………………………………………………..2
9 前角、后角的检测………………………………………………………………………………………………………………………………2
9.1 检测方法……………………………………………………………………………………………………………………….2
9.2检测器具……………………………………………………………………………………………………………………………………………………3
10 侧隙角的检测….…………………………………………………………………………………………………………………………………………3
10.1检测方法.……………………………………………………………………………………………………………………………………3
10.2 检测器具……………………………………………………………………………………………………………………………………………4
11 硬度的检测……………………………………………………………………………………………………………………………………………… 4
12标志的检测……………………………………………………………………………………………………………………………………………………4
13 包装的检测……………………………………………………………………………………………………………………………………4
14 表面处理的检测…………………………………………………………………………………………………………………………………………4